Throttle Delay Options - Glendinning EEC4 Installation Manual

28
EEC4 Installation Manual

Throttle Delay Options

The Throttle Delay Option allows you to configure the EEC system to delay throttle output as you shift
from Neutral, past in-gear idle, and into the throttle range.
Neutral
Moving handles from Neutral,
past in-gear idle into throttle range . . .
Throttle
range
system will shift transmission
into gear and pause . . .
To Change Throttle Delay Setting Follow These Steps:
Enter Configuration Mode as described in section 2.4A (pg. 29)
ACTION
Press ACTIVE
4 times for
Throttle Delay
Option
Press
WARM to
activate
selection
Press &
Release
ACTIVE
to cycle
through
Throttle Delay
Options
Press
WARM to
save option
selection
Configurable
0-2.5 second
Delay
(Default = 1 second)
LEDs ON
1
Port Neutral
2
3
Port Neutral & Active
4
5
Port Neutral & Warm
6
You may continue to other configuration options
on the following pages or you may choose to
EXIT CONFIGURATION MODE by turning
system OFF, moving control handles back to
NEUTRAL, and then turn system ON again.
before RPMs are increased.
above idle
RESULT
WARM LED will begin to flash
NO LEDs will be illuminated
AMOUNT OF DELAY
None
Active 1.0 second (Default)
Warm
None
0.5 second
1.5 second
2.0 second
2.5 second