Cp Pinout Description; Control Processor Pinout Description - Glendinning EEC4 Installation Manual

Control Processor Pinout Description

DC Power Connector (4 pin-Gray)
(1) Battery Positive 1
(2) Battery Positive 2
PORT Gear / Start Interlock / CP Enable Connector (12 pin-Gray)
(1) PORT Ahead gear Positive (+)
(2) PORT Astern Gear Positive (+)
(3) PORT Start Interlock 1
(4) PORT Ignition/CP Enable
Switch Input
(5) Enable Switch Power
(6) Spare Output (Com)
NOTE: Jumper #4 to #5 for Dry Contact CP Enable OR Apply 12v DC
positive to #4 for ignition power CP enable.
STBD Gear / Start Interlock / CP Enable Connector (12 pin-Gray)
(1) STBD Ahead gear Positive (+)
(2) STBD Astern Gear Positive (+)
(3) STBD Stat Interlock 1
(4) STBD Ingnition/CP Enable
Switch Input
(5) Enable Switch Power
(6) Not Used
PORT/STBD Throttle Connectors - Voltage Type (8 pin-Black)
(1) Not used
(2) Ref. voltage Pos.+
(3) Ref. voltage Neg.-
(4) Voltage Output Signal
(3) Battery Ground 1
(4) Battery Ground 2 (optional, if required)
(7) Spare Output (N.O.)
(8) Not Used
(9) PORT Ignition Output
(10) PORT Start Interlock 2
(11) PORT Astern gear Negative (-)
(12) PORT Ahead gear Negative (-)
(7) Not Used
(8) Not Used
(9) STBD Ignition Output
(10) STBD Start Interlock 2
(11) STBD Astern gear Negative (-)
(12) STBD Ahead gear Negative (-)
(5) Not Used
(6) Not Used
(7) Not used
(8) Chassis ground
Section 2.0 — Appendix / Reference
19
Bond
1
4
2
3
DC Power
12 1
11 2
10 3
9 4
8 5
7 6
Port Gear
Start Interlock
12 1
11 2
10 3
9 4
8
5
7
6
Stbd Gear
Start Interlock
1
8
2
7
3
6
4
5
PORT
Throttle
1
8
2
7
3
6
4
5
STBD
Throttle
Station Cable