Hooking Up Your Trailer; Securing Your Child - Burley Honey Bee Owner's Instruction And Safety Manual

Hooking up Your Trailer

1. Quick Release or Nutted Axle: Remove quick-release skewer or nut from
the left side of bike's rear wheel axle. Install hitch between quick-release
or nut and frame (Figure 14). Tighten the quick-release or nut following
manufacturer's recommendation. The hitch can remain on the bike when
trailer is removed. Consult Burley.com for accessories designed to help fit
your trailer to your bike.
Thru Axle: Consult Burley.com to obtain proper fit and installation to your
bike (Figure 15).
2. Hooking the tow bar to the hitch: Insert flex connector in between the two
holes on the hitch. Insert retaining pin and close retainer. Wrap safety strap
around the frame of the bike twice and latch to the D-ring on the tow bar
(Figure 16).
3. Removing the tow bar from the hitch: Unlatch the safety strap from the
D-Ring and unwrap it from the frame of the bike. Open the retainer on the
retaining pin and remove it. Then remove the flex connector from the hitch.

Securing Your Child

1. Before loading or unloading your children, set the
parking brake. After loading, secure and adjust the
harnesses. Snap shoulder straps & waist straps
into 5-point harness buckle and adjust straps so
they are secure (17a). Fasten and adjust lap belt(s)
to fit securely.
2. To remove your children, simply press the yellow
release button on the 5-point harness (17a).
3. When using double trailer with one child, always seat
the child in the right side position (Figure 18).
WARNING
Avoid serious injury from falling or sliding out.
Always use 5-point harness.
Figure 15
A
OWNER'S INSTRUCTION & SAFETY MANUAL
Figure 14
Figure 17
Figure 16
Figure 18
BURLEY.COM ENG
5