Advertisement
참고
Feference고
1. Front plate, door
2. Space between the front plate and the DRUM
[ How to adjust the front plate and the drum ]
(Warning): You should start adjusting after turning off the power and contact service
center if you do not fully understand the directions to adjust
① Insert lens bolt into the the A stopper of front plate then loosen the stopper by
turning left
② Slightly loosen fixing the bolt of the B stopper(Bearing part)
● Fix the B stopper with your hand so it won't move when you narrow down the
space of the drum then turn it left
(You can fix the drum with your hand and turn the B stopper )
● Fix the B stopper with your hand so it won't move when you widen the space of the
drum then turn it right
③ Once adjustment is completed, tighten the fixing bolt of the A and B stopper
① Leave about 0.5m/m space between front plate
and the door so that no coffee wastes can leak
② Fixing bolt on the front plate and washer have to
be the same ones as existing ones
(Otherwise, friction between the drum and the front
plate might cause noise obstructing rotation of the)
drum
1.2m/m is ideal space
between the front plate
and the drum .
It is important to
maintain the space as the
space gets narrow down
as a result of thermal
expansion . Noise is to
be caused from the drum
when the space is too
narrow.
27
Advertisement
