10.
Lift the DGPU up by the tab at the fan end and pull the DGPU up out of the chassis.
Installing the access panel of the HP EliteDesk 800 35W
This procedure includes installing the DGPU and the access panel.
1.
Set the DGPU into the chassis and secure it to the system board with three screws: two screws at the fan
end of the DGPU and one screw at the inner corner of the opposite end of the DGPU (1).
2.
Plug the fan cable into the connector (2) on the system board.
3.
Place the access panel on the computer and slide it back (1).
Removing and installing the access panel of the HP EliteDesk 800 35W
13