HP EliteDesk 800 Hardware Reference Manual page 24

9. Slide the new memory module (1) into the slot at approximately a 30° angle, and press the memory
module down (2) so that the latches lock it in place.
NOTE:
on the memory module slot.
10. Tilt the fan down, and then press the fan down until the it clicks into place.
CAUTION:
11. Install the access panel.
For instructions on installing the access panel on a 35W model, see
●
the HP EliteDesk 800 35W on page
For instructions on installing the access panel on any other model, see
●
on page
12. If the computer was on a stand, replace the stand.
13. Reconnect external devices, plug in the power cord, and then turn on the computer. The computer
automatically recognizes the new memory.
14. Lock any security devices that were disengaged when the access panel was removed.
18 Chapter 3 Hardware upgrades
A memory module can be installed in only one way. Match the notch on the module with the tab
Avoid pulling the fan cable.
11.
13.
Installing the access panel of
Installing the access panel