Operational Notes; Remote Operation - AT&T Digital Magic Messenger System Operation Instructions Manual

AT&T Digital Magic Messenger

Operational Notes

1 .
If the telephone line has "call-waiting," this service must be
terminated by your phone company in order for the Magic
Messenger to operate properly.
2 . The RECORD, PLAY and MODE lights flash when you first apply
power or following a power interruption of over 2 hours in
duration (announcements erased).
3 .
The Magic Messenger will answer an incoming call before you
hear it ring. The PLAY light will come on to indicate the unit has
answered a call (after the announcement has played, the light will
go out). After playing the message, the Magic Messenger will ring
through whenever the caller presses a touch tone button on his
phone. If the caller is not using a touch tone phone, the Magic
Messenger will ring through automatically after 15 seconds.
During this waiting period, the caller will hear a beep tone every
few seconds. The typical cycle will be: 15 second delay with
beeps followed by 2 sec. tone, 4 sec. delay and then ring the local
telephone. A disconnect signal or DTMF tone will interrupt the
process and cause the unit to either disconnect or ring
immediately to the local extension.
4 . If a caller does not hang up within 2-3 seconds after the
announcement has finished playing, but hangs up before the 15
second waiting period is complete, the unit may produce a short
ring at your attendant console or telephone extension.

Remote Operation

Remote operation lets you:
Select the day or night announcement from any touch tone phone.
Listen to the night announcement.
Record a new night announcement.
Change your remote access password.
14