Cable Connections; Changing The Internal Battery; Warranty - Vega INFO-1 Operating Manual

Vega INFO-1 Operating Manual

10.2 Cable connections

Main connector (D15HD connector: Unit Female, Cable Male)
D15HD Pin
1
2
3
4
5
7
10
15

11 Changing the internal battery

The INFO-1 uses an internal Lithium battery to supply power to run the internal clock. If you find the INFO-1 looses time
when you switch off main power you should replace the battery. This battery is of type CR2032. It is used in many
calculators and similar equipment and is easy to obtain. Remove the 2 securing nuts next to the D-15 connector and
remove the unit from its enclosure. The battery holder is located on the circuit board behind the display. Observe correct
polarity when installing a new battery. The side marked "+" will be viewable once the battery is inserted.
12 Cleaning
The unit should not be cleaned with any abrasive substances. The screen is very sensitive to certain cleaning materials
and should only be cleaned using a clean, damp cloth.
Warning: The INFO-1 is not waterproof, serious damage could occur if the unit is exposed to
water and/or spray jets.

13 Warranty

This product carries a warranty for a period of one year from date of purchase against faulty workmanship or defective
materials, provided there is no evidence that the unit has been mishandled or misused. Warranty is limited to the
replacement of faulty components and includes the cost of labor. Shipping costs are for the account of the purchaser.
Note: Product warranty excludes damages caused by unprotected, unsuitable or incorrectly wired
electrical supplies and or sensors, and damage caused by inductive loads.
Color
Red 8-30Vdc power via power switch / circuit
breaker and fuse.
Black Ground. Connect the ground to the engine
block, and the engine block to the battery
negative. Do not connect the INFO-1 ground
directly to the battery negative. This must be
routed via the engine block.
- RS232 Transmit data (Firmware upgrading)
- RS232 Receive data (Firmware upgrading)
Green Current sender input
Orange OAT Sender input
Grey Flight timer remote start/stop
(Leave open if remote start stop not required)
Low = Run flight timer
Open = Stop flight timer
White Alarm Output (Open collector)
Function
Page 23