Configuring Additional System Parameters - Dell EMC Data Domain DD6300 Installation Manual

ethMc no
ethMd no
ethMe no
ethMf no
----- -------
Do you want to save these settings (Save|Cancel|Retry):

Configuring additional system parameters

no n/a
no n/a
no n/a
no n/a
----- ----
Most installations would benefit from the configuration of a few additional system
parameters, provided in this section for convenience.
Note
You can also use the Data Domain (DD) System Manager GUI interface to configure
the system parameters. Open a web browser, and enter your Data Domain system's IP
address in the browser's address text box. Log in when the DD System Manager login
screen displays. Use the DD System Manager online help for more information.
Procedure
1. To set up the mail server, enter:
# config set mailserver mail.datadomain.com
The Mail (SMTP) server is: mail.datadomain.com
2. To set up the system location, enter:
# config set location "Dallas Regional Data Center Lab,
5000 Apple Drive Suite #130, Dallas, Tx"
The System Location is: Dallas Regional Data Center Lab,
5000 Apple Drive Suite #130, Dallas, Tx
3. To add one or more time servers, enter:
# ntp add timeserver 192.168.101.1
Remote Time Servers: 192.168.10.1
4. To enable the NTP daemon, enter:
# ntp enable
NTP enabled.
5. To change the system time zone, enter:
# config set timezone US/Central
The Timezone name is: US/Central
*** You made a change to the timezone setting.
this change
*** (in currently running processes), you need to reboot the
machine.
6. Reboot the system for the time zone change to take effect:
# system reboot
The 'system reboot' command reboots the system. File access is
interrupted during the reboot.
Are you sure? (yes|no|?) [no]: yes
ok, proceeding.
The system is going down for reboot.
7. After the system completes the reboot, login again as
number as a password. Press
password prompt, and config setup wizard.
8. Generate an autosupport sent to yourself to use as ACG input:
# autosupport send your.email@emc.com
OK: Message sent.
n/a n/a
n/a n/a
n/a n/a
n/a n/a
-------------- ------------------------
to get through the EULA, sysadmin
Ctrl-C
Configuring additional system parameters
Configure System for Use
To fully effect
using the serial
sysadmin
35