Remington i-LIGHT Manual page 15

ENGLISH
, The treated areas become red after treatment.
• This is normal and the redness should subside. If not, try using a lower energy level.
, BE AWARE: If the unit is used over an extended period of time, the unit might automatically disable
momentarily (estimated 40 seconds) to cool down. Once the unit has cooled down, it will be ready to
use again.
All currently selected energy level
indicators flashing.
All energy level indicators flashing.
LED's
All LED's flashing with warning beep.
Not full contact.
SOUNDS
Replace bulb.
Skin contact sensors stuck.
Unit is overheated and is disabled
momentarily to cool down.
Unit is malfunctioning. Turn the unit off,
wait a few moments and try again. If
problem persists, the unit should be
returned for repair.
Treatment head is removed or loose.
Flash button was pressed while the skin
contact sensor was not fully engaged.
Bulb is missing or needs to be replaced.
Flash button was pressed after the skin
contact sensor had been engaged since
unit start up. Skin contact sensor may be
stuck.
15