Cleaning And Care; Disposal Considerations - Klarstein 10020108 Manual

No ice is made.
The lights of ice full and deficient
come at in the same time.
Machine keeps running, but the
water is warmer than the nomal
water.
• Clean the inner Iiner, ice collecting tray, water box, ice shovel and evaporator frequently. When cleaning,
unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to clean the inside
and the outside surface of the ice maker. Do not spray the ice maker with chemicals or diluted agents such
as acids, gasoline or oil. Rinse thoroughly before starting.
• Do not use mechanical devices to accelerate the defrosting process.
• If the icemaker is reused after a long time, the water pump may not pump sufficient water due to an air
block, the deficient water indicator turns on in this case . To correct this press the START button again, then
the icemaker will work normally.
• To ensure the cleanliness of the ice cubes, water in the water reservoir should be replaced every 24 hours.
• If the compressor stops for any reason such as water shortage, too much ice, power off, etc. Do not start
the system right away, wait 3 minutes, and then re-start the ice maker.
• Always use fresh water before starting ice production either at initial installation or after a long shut-off
period.
According to the European waste regulation 2012/19/EU this symbol on the product or on
its packaging indicates that this product may not be treated as household waste. Instead it
should be taken to the appropriate collection point for the recycling of electrical and electron-
ic equipment. By ensuring this product is disposed of correctly, you will help prevent potential
negative consequences for the environment and human health, which could otherwise be
caused by inappropriate waste handling of this product. For more detailed information about
recycling of this product, please contact your local council or your household waste disposal
service.
11
There is no refrigerant in the com-
pressor.
Compressor is broken down, fan
motor is broken.
Water tray is blocked is blocked by
ice cube.
The magnetic valve is broken.

Cleaning and Care

Disposal Considerations

Call for service.
Clar the ice cube under the ice
shovel. Pull out the plug and in-
sert it again. Then press the „ON/
OFF" button, two minutes later the
michine will restart automatically:
Replace the magnetic valve.