Troubleshooting - Klarstein 10020108 Manual

Before use
• Before using the Iee maker for the first time, please wait 2 hours after positioning it, and keep the front Iid
open for at least 2 hours.
• Destilled water is not allowed to be used on this unit.
• Do not use this appliance with water that stood for longer than 24 hours.
Operation
1. Open the Iid and fill the water reservoir with water. Make sure the water Ievei in the water reservoir is not
over the Iee collecting tray.
2. Connect to the power.
3. Press ON/OFF button to turn unit on. The ice maker begins to work.
4. If indicator ICE FULL is in red with ,DI DI' noise, please take out the ice with the scoop.
5. Press ON/OFF button to stop the machine. Remove the plug
Notes:
• If no water is pumped up to the water tray over two cycles but the water in water tank is enough,then
please move the unit ahead a little,then remove the silicon stopper,and Iet several drops water runs out.
• Note: When the ice collecting tray is full please remove the ice immediately, Do not allow the ice collecting
• tray to overfill.
Problem
The compressor works abnormally
with a buzzing noise.
Water shortage indicator light is on. There is no water.
Indicator lights on display are not
on.
The ice is made too large and with
pieces sticking together.

Troubleshooting

Possible Cause
The voltage is lower than recom-
mended.
The pump is full of air.
Blown fuse / no power.
Ice of previous cycles left in the
water tray.
The evaporator is too low.
Suggested Solutions
Stop the ice maker an do not re-
start until the voltage is normal.
Press the STOP button, fill in wa-
ter, wait 3 minutes and press the
start button to restart. When the
water has reached the fill line the
ice maker will restart automatically.
Remove the silicon stopper and let
several drops of water run out.
Replace fuse / Turn power on.
Stop the unit right away, restart the
unit till the ice in water tray melt
down.
Shift the evaporator a little.
10