Table of Contents
Advertisement
Grinding, Abrasive cutting-off and Wire Brushing Instructions
TO pREVENT SERIOUS INJURy: Grip the tool firmly in both hands.
1. Make sure that the Power Switch is in the
off-position, then attach the Battery Pack.
2. Push Power Switch forward and
down to start the tool.
3. Allow the tool to come up to full speed
before touching the work material.
4. Apply the wheel to the work material at a 10° – 15°
angle, allowing the tool to operate at full speed.
If the tool bogs down, use lighter pressure.
Sanding Instructions
TO pREVENT SERIOUS INJURy: Grip the tool firmly in both hands.
1. Wipe the work surface clean of all dirt and debris,
especially that of previous
coarser sanding sessions, which will scratch
the surface of a finer grit sanding session.
2. Attach the desired grit Sanding Disk
(sold separately) onto the Backing Pad.
3. Make sure that the Power Switch is in the
off-position, then attach the Battery Pack.
4. Push Power Switch forward and
down to start the tool.
5. Wait until the tool has reached full speed,
then gently contact the surface.
Page 14
For technical questions, please call 1-888-866-5797.
5. To create a smoother surface,
keep the tool moving over the work surface.
6. TO pREVENT AccIDENTS, AFTER USE:
Turn off the tool.
WARNING! Allow the tool to come to a
complete stop before setting it down.
Remove Battery Pack. Clean, then store
the tool indoors out of children's reach.
6. Keep heavy pressure off of the tool when operating.
Allow the tool to do the work.
7. Move the tool in a uniform pattern up and down or
side to side while sanding to ensure even sanding.
8. Periodically, stop the tool and check for disc wear.
Replace worn sanding discs as needed.
9. TO pREVENT AccIDENTS, AFTER USE:
Turn off the tool.
WARNING! Allow the tool to come to a
complete stop before setting it down.
Remove Battery Pack. Clean, then store
the tool indoors out of children's reach.
Item 63632
Hide quick links:
Advertisement
Table of Contents
