Grounding; Double Insulated Tools: Tools With Two Prong Plugs; Extension Cords; Symbology - Bauer 20V Hypermax Lithium Owner's Manual & Safety Instructions

Grounding

TO pREVENT ELEcTRIc SHOcK AND DEATH FROM
INcORREcT GROUNDING WIRE cONNEcTION:
check with a qualified electrician if you are in doubt as to whether the outlet is properly
grounded. Do not modify the power cord plug provided with the tool. Never remove the
grounding prong from the plug. Do not use the tool if the power cord or plug is damaged. If damaged,
have it repaired by a service facility before use. If the plug will not fit the outlet, have a proper outlet
installed by a qualified electrician.

Double Insulated Tools: Tools with Two prong plugs

Outlets for 2-prong plug

Extension cords

Note: Extension cords must not be used with this item's Charger.

Symbology

Double Insulated
Canadian Standards Association
Underwriters Laboratories, Inc.
V
Volts
~
Alternating Current
A
Amperes
No Load Revolutions
n 0 xxxx/min.
per Minute (RPM)
Item 63632 For technical questions, please call 1-888-866-5797.
1. Tools marked "Double Insulated" do not
require grounding. They have a special
double insulation system which satisfies OSHA
requirements and complies with the applicable
standards of Underwriters Laboratories, Inc.,
the Canadian Standard Association,
and the National Electrical Code.
2. Double insulated tools may be used in either of the
120 volt outlets shown in the preceding illustration.
(See Outlets for 2-prong plug.)
WARNING marking concerning Risk
of Eye Injury. Wear ANSI-approved
safety goggles with side shields.
Read the manual before
set-up and/or use.
WARNING marking
concerning Risk of Fire.
Do not cover Charger
ventilation ducts.
Charge on fireproof surface only.
WARNING marking concerning
Risk of Electric Shock.
Properly connect Charger's power
cord to appropriate outlet.
WARNING marking concerning
Risk of Explosion.
Do not puncture, short, or open
battery packs and do not charge
damaged battery packs.
Page 9