Specifications
Setup - Before Use:
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Make sure that the power Switch is in the off-position and remove its
Battery pack before performing any procedure in this section.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
ASSEMBLy
Installing the Wheel Guard
TO pREVENT SERIOUS INJURy: Do not operate this tool without the Wheel Guard properly installed.
1. Unlock the Wheel Guard Handle.
2. Align Tabs on Wheel Guard with
Notches on Gear Housing.
3. Slide Wheel Guard over the rim
of the Gear Housing.
4. Rotate the Wheel Guard as needed to
shield you during the planned work.
Installing the Side Handle
TO pREVENT SERIOUS INJURy:
Do not operate this tool with one hand only or without the Side Handle properly installed.
1. The Side Handle may be installed on
either side of the Gear Housing.
Page 10
Battery
No Load Speed
Arbor Hole Diameter
Spindle Thread
Max. Accessory Diameter
Max. Wheel Thickness
For technical questions, please call 1-888-866-5797.
Bauer 20 V Li-ion (sold separately)
7000 RPM
7/8"
5/8" x 11 TPI
4-1/2" (115 mm)
1/4"
5. Lock the Wheel Guard Handle.
6. Tighten the Wheel Guard Nut securely.
7. Check the Wheel Guard to ensure
it is firmly in place. Adjust if
necessary before proceeding.
2. Screw the threaded end of the
Side Handle into the selected position.
Tighten securely before beginning work.
Item 63632