Workpiece And Work Area Set Up; Installing A Threaded Accessory; Battery Charging - Bauer 20V Hypermax Lithium Owner's Manual & Safety Instructions

Installing a Threaded Accessory

TO pREVENT INJURy: Wear heavy-duty work gloves when handling wire wheels and brushes.
These accessories are sharp and can cause injury.
1. The accessory MUST be:
• rated to at least 7000 RPM.
• no larger than 4-1/2" (115 mm) in diameter.
• fitted with a threaded opening of 5/8" x 11 TPI.
• undamaged.
• a sanding disc and backing pad, or
a sanding flap disc; a wire wheel, or
a wire cup brush; (accessories not included).

Battery charging

Charge battery before using this tool. Follow instructions included with battery charger.

Workpiece and Work Area Set Up

1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
3. There must not be hazardous objects, such
as utility lines or foreign objects, nearby
that will present a hazard while working.
Item 63632 For technical questions, please call 1-888-866-5797.
2. Press in and hold the Spindle Lock Button
to prevent the Spindle from turning.
3. Remove the Outer Flange and the
Inner Flange and keep in a safe place.
4. Thread disc accessory firmly onto the Spindle.
Wrench tighten onto the spindle.
4. You must use personal safety equipment including,
but not limited to, ANSI-approved eye and hearing
protection, as well as heavy-duty work gloves.
5. Before beginning work, provide for sparks
and debris that will fly off the work surface.
Page 13