Table of Contents
Advertisement
O
—
m
>
=
Oo
Zz
Installing
a Threaded Accessory
AUTION
TO PREVENT |
NJURY: Wear heavy-duty work gloves when handling wire wheels and brushes.
These accessories are sharp and can cause injury.
1.
The accessory MUST be:
2.
Press in and hold the Spindle Lock Button
* rated to at least 11,000 RPM.
to prevent the Spindle from turning.
* no larger than 4-1/2" (115 mm) in diameter.
* fitted with a threaded opening of 5/8- 11 UNC.
3. Remove the Outer Flange and Inner
* undamaged.
Flange, and keep in a safe place.
~ i sanding aiee ane Racninig pad, OF
4.
Thread disc accessory onto the Spindle.
a sanding flap disc; a wire wheel, or
;
'
:
}
;
:
Wrench tighten onto the Spindle.
a wire cup brush; (accessories not included).
Workpiece and Work Area Set Up
1.
Designate a work area that is clean and well-lit.
4.
There must not be hazardous objects, such
The work area must not allow access by children
as utility lines or foreign objects, nearby that
or pets to prevent distraction and injury.
will present a hazard while working.
2.
Route the power cord along a safe route
5.
You must use personal safety equipment including,
to reach the work area without creating a
but not limited to, ANSI-approved eye and hearing
tripping hazard or exposing the power cord to
protection, as well as heavy-duty work gloves.
possible damage.
The power cord must
\
6.
Before beginning work, provide for sparks
reach the work area with enough extra length
to allow free movement while working.
3.
Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
and debris that will fly off the work surface.
Hauer
Page 14
For technical questions, please call 1-888-866-5797.
Item 64856
Advertisement
Table of Contents
