Maintenance - Husqvarna 320iB Operator's Manual

Automatic shutdown function
The product is equipped with a shutdown function that
deactivates the product after 30 minutes if it is not used.
To stop the product
Note: Always remove the battery to prevent the product
being started by accident.
1. Release the power trigger.
2. Move the ON/OFF switch lever to OFF position.
Introduction
WARNING: Before you do any maintenance
work you must read and understand the
safety chapter.

Maintenance

Clean the outside of the machine with a clean and dry cloth. Never use water.
Keep handles dry, clean and free from oil and grease.
Make sure that the start/stop button works correctly and is not damaged.
Make sure the power trigger is functioning properly with regard to safety.
Check that nuts and screws are tight.
Check that the battery is intact.
Check the battery's charge.
Check that the release buttons on the battery works and locks the battery into
the machine.
Check that the battery charger is intact and functional.
Check that all couplings, connections and cables are intact and free from dirt.
Check the connections between the battery and the machine and also check the
connection between battery and the battery charger.
800 - 001 - 31.08.2018
3. Remove the battery from the product. Press the two
release buttons and pull out the battery.
Maintenance
Maintenance schedule
The following is a list of the maintenance steps that you
must do on the product.
WARNING: Remove the battery before you
do maintenance.
Daily Weekly
X
X
X
X
X
X
X
X
X
Monthly
X
X
11