Troubleshooting - Husqvarna 320iB Operator's Manual

To do a check of the air intake
1. Make sure that the air intake is not blocked on any
side on the product.
2. Stop the product and remove leaves or unwanted
material if necessary.
CAUTION: A blocked air intake
decreases the blowing capacity of the
product and increases the motor's
Troubleshooting of the product
Starting failure
The product does not start.
Troubleshooting of the battery
and/or charger
Troubleshooting the battery and/or the battery charger
during charging.
Battery
LED display
Green activate LED flashing
Error LED flashing
Error LED is lit
12

Troubleshooting

Possible faults
Low battery voltage
Recently changed battery.
The product has not been in operation for
more than 30 minutes.
Possible faults
Low battery voltage.
The battery is discharged.
Temperature deviation.
Permanent battery error
working temperature. This can result in
motor failure due to overheating.
To examine the battery and the
battery charger
1. Examine the battery for damages, for example
cracks.
2. Examine the battery charger for damages, for
example cracks.
3. Make sure that the battery charger connection wire
is intact and that there are no cracks in it.
To clean the product, the battery and
the battery charger
1. Clean the product with a dry cloth after use.
2. Clean the battery and battery charger with a dry
cloth. Keep the battery guide tracks clean.
3. Make sure that the terminals on the battery and the
battery charger are clean before the battery is put in
the battery charger or the product.
Possible action
Charge the battery.
Move ON/OFF switch lever to
OFF position and then to ON po-
sition to start the product again.
Troubleshooting does not include the backpack battery,
refer to separate manual.
Possible action
Charge the battery.
Charge the battery.
Use the battery in surroundings where tem-
peratures are between -10°C (14°F) and
40°C (104°F).
Speak to your servicing dealer.
800 - 001 - 31.08.2018