Dip Switch; Mj20-Mem1 Technical Specifications; Memory; Environmental - Unitronics MJ20-MEM1 Installation Manual & Technical Specifications

4/06

DIP Switch

There are two switches on the Cloner.
1: - ON enables you to both read from and write to the Cloner
- OFF enables you to apply write protection. This enables read-only
2: This switch is for factory use only. It is set in the ON position. Do not move it.

MJ20-MEM1 Technical Specifications

Memory

Memory type

Environmental

Operating temperature
Storage temperature
Relative Humidity (RH)

Dimensions

Weight

The information in this document reflects products at the date of printing. Unitronics reserves the right, subject to all applicable laws, at any time, at its sole
discretion, and without notice, to discontinue or change the features, designs, materials and other specifications of its products, and to either permanently or
temporarily withdraw any of the forgoing from the market.
All information in this document is provided "as is" without warranty of any kind, either expressed or implied, including but not limited to any implied warranties of
merchantability, fitness for a particular purpose, or non-infringement. Unitronics assumes no responsibility for errors or omissions in the information presented in
this document. In no event shall Unitronics be liable for any special, incidental, indirect or consequential damages of any kind, or any damages whatsoever arising
out of or in connection with the use or performance of this information.
The tradenames, trademarks, logos and service marks presented in this document, including their design, are the property of Unitronics (1989) (R"G) Ltd. or other
third parties and you are not permitted to use them without the prior written consent of Unitronics or such third party as may own them.
2
Read Only
Flash
0° to 50°C (32° to 122°F)
-20° to 60° C (-4° to 140°F)
10% to 95% (non-condensing)
71 mm (2.795")
24g (0.85oz.)
Read / Write
Internal use only
Keep ON
20 mm (0.787")
MJ20-MEM1
5414-0040-8
Unitronics