Special Functions; Punch Through Channel; Punch Through Volume; Macro Power - THOMSON ROCZ107 Operating Instruction

6. Special Functions

6.1 Punch Through Channel

The Punch Through Channel allows the CH+ or
CH- commands to bypass the currently controlled
device and switch the channels on a second device.
All other commands remain uninfluenced.
To activate the punch through channel setting:
• Press desired device mode key (e.g. TV).
• Press and hold "CH+" key.
• Press desired device mode key (e.g. SAT).
• Release "CH+" (the indicator flashes once if the
setting is activated).
To deactivate the punch through channel setting:
• Press desired device mode key (e.g. TV).
• Press and hold "CH-" key.
• Press desired device mode key (e.g. SAT).
• Release "CH-" (the indicator is flashing twice if
the setting is deactivated).

6.2 Punch Through Volume

The Punch Through Volume allows the VOL+ or
VOL- commands to bypass the currently controlled
device and adjust the volume on a second device.
All other commands remain uninfluenced.
To activate the punch through volume setting:
• Press desired device mode key (e.g. TV).
• Press and hold "VOL+" key.
• Press desired device mode key (e.g. SAT).
• Release "VOL+" (the indicator flashes once if
the setting is activated).
4
To deactivate the punch through volume setting:
• Press desired device mode key (e.g. TV).
• Press and hold "VOL-" key.
• Press desired device mode key (e.g. SAT).
• Release "VOL-" (the indicator is flashing twice if
the setting is deactivated).

6.3 Macro Power

Macro Power enables you to turn two TV/STB
devices on/off simultaneously.
To activate the macro power setting:
• Press desired device mode key (e.g. TV).
• Press and hold "POWER" key.
• Press desired device mode key (e.g. SAT).
• Release "POWER" (the indicator flashes once if
the setting is activated).
To deactivate the macro power setting:
• Press desired device mode key (e.g. TV).
• Press and hold "POWER" key.
• Press desired device mode key (e.g. SAT).
• Release "POWER" (the indicator is flashing
twice if the setting is deactivated).
7. LEARN MODE
This remote control is equipped with a learning
function. Thus, you could learn functions of your
original remote to this remote control.
7.1 BEFORE STARTING LEARN MODE
• The batteries in the two remote controls have to
be in good condition. Replace them if necessary.
• Place the remote controls with the infrared
diodes so that they point towards each other.
• Where necessary adjust the height of both
remotes so that infrared diodes are properly
aligned.
• The distance between the remote controls should
be about 3 cm.
ROC1117GRU
ZAPPER
ORIGINAL
ca. 3 cm