Woods BRUSHBULL BB48X Operator's Manual page 28

SEAL REPAIR
(ON CAST/CROWN TOP BB48X, BB60X,
BB72X - S/N 1159929 AND ABOVE ONLY)
(Figure 19)
Vertical Shaft Seal Repair
1. Disconnect and remove the rear driveline from the
gearbox.
2. Remove vent plug (9) and siphon gear lube from
housing through this opening.
3. Remove crossbar (see Crossbar Removal, page
31).
4. Remove output cap (17) and output seal (16) by
removing four cap screws (13) and washers (12).
Replace with new seal (see Seal Installation,
page 24).
Vertical seal should be recessed in output cap.
NOTE: Distortion to seal cage or damage to seal
lip will cause seal to leak.
28 Dealer Service
Figure 19. Cast/Crown Top Gearbox Assembly
5. Secure output cap (17) on to bottom of gearbox
using four cap screws (13) and lock washers (12).
NOTE: Make sure output gasket (10) and (11) are
in place.
6. Fill gearbox with SAE 80W or 90W gear lube until it
runs out the side level plug.
7. Remove and replace any seal damaged in
installation.
Horizontal Seal Leak Repair
1. Disconnect and remove the rear driveline from the
gearbox.
2. Remove vent plug (9) and siphon gear lube from
housing through this opening.
3. Remove input seal (4). Replace with new one
(refer to Seal Installation, page 24).
4. Fill gearbox with SAE 80W or 90W gear lube until it
runs out the side level plug.
1. Housing
2. Inspection cover
3. 22 Tooth gear
4. Input seal
5. Input shaft
6. Retaining ring
7. Gear spacer
8. Retaining ring
9. Vent Plug and Washer
10. Output gasket (0.30)
11. Output gasket (0.13)
12. Lock washer
13. M10 x 1.5 x 25 Cap screw
14. 1" - 14 Slotted flange nut
15. Cotter pin
16. Output seal
17. Output cap
18. Output bearing spacer
19. Output shaft & pinion
20. Ball bearing
21. Ball bearing
22. Sealing washer
23. M8 Lock washer
24. M8 x 1.5 x 25 Cap screw
25. Bearing Cup and Cone
26. Shim Kit
27. Output Bearing Spacer
(Rev. 5/11/2010)
MAN0632 (5/15/2007)