Woods BRUSHBULL BB48X Operator's Manual page 41

3. Install driveline onto gearbox input shaft and
secure with bolt (1) and nut (2).
4. Secure driveline with bolt (1) and nut (2).
5. Lubricate rear driveline half and install front
driveline half.
6. Attach tether chain to diagonal brace bar.
1. 1/2 NC x 3 Cap
screw GR8 (Clutch)
2. 1/2 NC Lock nut
3. Clutch shield
4. M8 x 1.25P x 20 mm Cap screw
5. 5/16 Lock washer
6. 5/16 Flat washer
Figure 39. Slip Clutch Driveline Assembly
(BB48X & BB60X Optional)
(BB72X & BB84X Standard)
Driveline Slip Clutch - BB72X and BB84X
1. Before operating slip clutch, make sure it will slip.
Refer to Slip Clutch Adjustment, page 20.
2. Position clutch shield (3) against gearbox. Secure
using cap screw (4), lock washers (5), and flat
washers (6). Torque hardware to 12 lbs-ft.
3. Install driveline onto gearbox input shaft and
secure with bolt (1) and nut (2).
4. Secure drive by releasing lock collar slide onto the
gearbox shaft and release lock collar when balls
are seated into groove. Pull on drive to insure drive
is secure.
INSTALL SAFETY SHIELDING
Chain Shielding (Optional)
 Full chain, rubber, or steel band shielding must
be installed when operating in populated areas or
other areas where thrown objects could injure peo-
ple or damage property.
(Rev. 5/10/2009)
MAN0632 (5/15/2007)
ANGER
• If this machine is not equipped with full chain,
rubber, or steel band shielding, operation must
be stopped when anyone comes within 300 feet
(92 m).
• This shielding is designed to reduce the risk
of thrown objects. The mower deck and protec-
tive devices cannot prevent all objects from
escaping the blade enclosure in every mowing
condition. It is possible for objects to ricochet
and escape, traveling as much as 300 feet (92 m).
The optional chain shielding assemblies are ready for
installation when you receive them.
1. Refer to Front & Rear Chain Shielding, page 60,
and attach as shown by inserting the bolts from
inside the cutter frame out through the shielding.
2. Install hardware as shown in the parts drawing.
Rubber Deflector (Standard)
Attach rubber deflector (1) and link (2) to front of cutter
using carriage bolts (3) and flange lock nuts (4).
Figure 40. Rubber Deflector Installation
FILL GEARBOX
NOTICE
■
Gearbox is not filled at the factory. Prior to deliv-
ery to customer, make sure gearbox is filled only
half-full with 80W or 90W API GL-4 or GL-5 gear
lube. Use side plug to remove any excess oil.
1. Remove solid plug and discard.
2. Make sure vent plug hole is clear.
3. Fill gearbox until oil runs out the side plug on
gearbox. Use a high quality gear oil with a viscosity
index of 80W or 90W and an API service rating of
GL-4 or GL-5.
4. Install vent plug. Use pipe sealant or thread tape
on threads. Plug is shipped in the manual tube.
Assembly 41
1. Rubber deflector
2. Link
3. 3/8 NC x 1
Carriage bolt
4. 3/8 NC Flange
lock nut