Woods BRUSHBULL BB48X Operator's Manual page 31

CROSSBAR REMOVAL
1. It is necessary to gain access to bottom side of
cutter for crossbar
SERVICE, page 18.
NOTE: You will need to use either the puller screw
(Item 6, Figure 21) or a small hydraulic jack to
remove the crossbar.
2. To make crossbar removal easier, remove blades
as shown in Figure 20.
8. Crossbar
9. Blade
12. Blade pin
13. Shim
14. Keyhole plate
15. Blade pin lock clip
16. Shim
35. Cap screw
Figure 20. Blade Removal (BB84X Shown)
3. Remove cotter pin, castle nut, and washer from
bottom of crossbar, Figure 21.
4. Attach a clevis (1) to each end of crossbar, using
blade pins, spacers, keyhole plates, and blade pin
clips.
5. Position tube assembly (5) with threaded nut
toward crossbar for puller screw removal or down
for hydraulic jack removal.
6. For removal with puller screw, attach tube (5) to
each clevis with bolts (2) and nuts (3). Place pad
(4) in nut and thread puller screw (6) into nut from
bottom. Tighten until pad is solid against gearbox
shaft. For best results, strike head of puller screw
with a hammer while tightening with a wrench.
7. For removal with a jack, attach tube to each clevis
with puller links (7), bolts (2), and nuts (3). Place
jack on tube with end of jack pressing against
gearbox shaft. Slowly apply force with jack.
NOTE: Hydraulic jack will not operate if tipped
more than 90-degrees. Use care to prevent bend-
ing crossbar during removal.
MAN0632 (5/15/2007)
removal. See OWNER
1. Clevis
2. 5/8 NC x 4 Cap screw
3. 5/8 NC Hex nut
4. Pad assembly
5. Tube assembly
6. Screw assembly
7. Puller link
Figure 21. Crossbar Removal
Dealer Service 31