LG 32SE3D Owner's Manual page 64

10
Factory Reset
This feature allows you to restore all set values to their factory default values.
y y
If you set this feature to Yes, all Signage settings except UTT setting (the Signage panel's operational hours) are
y y
restored to their factory default settings.
(This feature may not be available with some models.)
All user settings will be reset.
Still Continue?
Yes
OPS/PC Power Control
You can control the power of the OPS (media player) by turning the display power on or off.
y y
Disable: Disables the PC Power Control.
y y
Sync (on): Synchronizes the power status of the OPS (media player) only when the monitor is turned on.
y y
Sync (on/off ): Synchronizes the power status of the OPS (media player) with the monitor.
y y
The PC Power Control feature can be used with the external RS-232C connection of the media player.
y y
(This feature may not be supported in certain models.)
Interface Selection
You can configure serial communication with the connected OPS.
y y
RS-232C: Enables communication with external devices via the serial port.
y y
OPS: Enables communication via the OPS connected to the product.
y y
Interface Selection is enabled only when the OPS kit is connected.
y y
(This feature may not be supported in certain models.)
Check Screen
The Check Screen feature judges whether there are abnormalities on the edges of the screen. R, G, and B
y y
OSDs are formed on the screen at one second intervals and an RGB sensor tests the areas.
If set to On, the Check Screen feature is enabled.
y y
If set to Off, the Check Screen feature is disabled.
y y
If the Portrait mode is set to 90 or 270, the Check Screen feature is off and deactivated.
y y
If the Pivot mode is On, the Check Screen feature is off and deactivated.
y y
When the Portrait mode and Pivot mode is off, the Check Screen feature is activated.
y y
(This feature may not be supported in certain models.)
No