LG 32SE3D Owner's Manual page 62

8
Intelligent Auto
You can set this feature to On (enabled) or Off (disabled).
y y
If you change the screen resolution after setting this feature to 'Yes' , the display is automatically adjusted to the
y y
new resolution.
(This feature may not be available with some models.)
Master/Slave Mode
This feature allows you to sync monitors connected via RS-232C.
y y
When various monitors are connected via RS-232C, the forefront monitor becomes the Master.
y y
Once the Master is selected, the rest become Slaves.
y y
If you want to change the Master monitor, you must change it in Master/Slave Mode.
y y
(This feature may not be available with some models.)
NOTE
The Master/Slave Mode menu is only enabled when Picture ID is set to Off.
y y
When entering or editing Master/Slave Mode, the menu cursors on the Slave monitors may not be moved.
y y
Time Sync Clock
This feature syncs the Slave monitors' clocks to the Master monitor's at a specified time via RS-232C.
y y
On the Master monitor, you can set the sync time as well as setting Time Sync Clock to Off .
y y
You can select a sync time between 0:00 - 23:00.
y y
While Time Sync Clock is performed, RS-232C control of other commands may not work.
y y
(This feature may not be available with some models.)
NOTE
To synchronize Time Sync Clock, be sure to set each slave monitor's clock so that they are at least one minute
y y
later than the master monitor's clock.
If the Clock setting is Auto, the setting is changed to Manual when Time Sync Clock runs.
y y