Crown GLTS-30 Installation And Operation Manual page 8

INSTALLATION AND OPERATION MANUAL, GAS SKILLETS, MODELS GLTS-30, GLTS-40
2.0 INSTALLATION INSTRUCTIONS (Continued)
WARNING: Never use an open flame to check for gas leaks. Check
all connections for leaks using soapy water before use.
After piping has been checked for leaks, all piping receiving gas should be fully purged to
remove air.
NOTICE: If this equipment is being installed at over 2,000 feet altitude and was
not so specified on order, contact service department. Failure to install with
proper orifice sizing may void the warranty.
PART NUMBER 10100R4 8 2005-10-14