Omron PRT1-COM Operation Manual page 95

Transistor Output Units
Connector Pin Arrangement
Wiring
84
Pin number
Function
Pin number
Function
Attach a FUJITSU connector to the Transistor Output Unit and connect to
external devices.
Applicable Connectors
Three types of connectors can be attached to the cable, depending to the
assembly method. When creating your own cables, use one of the following
connectors.
Manufacturer
FUJITSU
FCN361J024-AU
FCN363J024-AU
FCN367J024-AU/F
Connector Cables
When a Transistor Output Unit (connector) is to be connected to an OMRON I/O
Block or a Connector--Terminal Block Conversion Unit, use the cables (sold
separately) listed in the following table.
Manufacturer
OMRON
XW2Z-jjjA
G79-jjjC
Note V terminals and G terminals are respectively connected internally. When the I/O
power is being supplied, the power can be supplied to the output devices from
the V and G connectors. Current supplied in this way, however, must be less
than 2 A. If, instead of using the V and G connectors, the power supply is wired to
the terminal block as shown in the following diagram, the current supplied must
be less than 2.5 A.
A12 A11 A10 A9 A8 A7 A6
V NC V G OUT OUT OUT OUT OUT
07 06 05
B12 B11 B10 B9 B8 B7 B6
G
V NC V OUT OUT OUT OUT OUT
15 14 13
Model number
Model number
Connector--Terminal Block Conversion Unit
XW2B-20G4
XW2B-20G5
I/O Block
G7TC-OC16
G70D-SOC16
G70D-FOM16
G70A-ZOC16-3
M7F
Output Unit
I/O Block (example)
Section
A5 A4 A3 A2 A1
OUT OUT OUT
04 03 02 01 00
B5 B4 B3 B2 B1
OUT OUT OUT
12 11 10 09 08
Remarks
Soldered
Crimp
Pressure-welded
Corresponding device
Load
6-3