Setting The Humidity Level; Food Holding Guide - Hatco FLAV-R-FResh FDWD-12-2X Installation And Operating Manual

OPeRATION

setting the humidity Level

Use the following procedure to set the humidity level on
humidified units.
1. Press the key to enter humidity mode ("hSP" will
appear on the CABINET TEMPERATURE display).
2. Press the key again to show the current humidity level.
3. Press the key or
level. Humidity range is 1 through 5 (1 is the lowest amount
of humidity and 5 is the highest). See the "Food Holding
Guide" in this section for recommendations.
Figure 11. Setting the Humidity Level

Food holding Guide

Type of Food
Biscuits
Chicken Pieces (Fried)
Croissants
Fruit Pies
Onion Rings
Pizza — Thick Crust
Thin Crust
Pretzels
Wrapped Sandwiches
NOTE: all times and settings are recommendations only and may vary depending on product preparation, cooking time, and
internal food temperature.
key to reach the desired humidity
Maximum
holding Time
4 Hours
4 Hours
4 Hours
3-1/2 Hours
1/2 to 1 Hour
1 Hour
1 Hour
3 Hours
2 Hours
4. After the desired humidity level is set, wait 15 seconds
without pushing any keys for the CABINET TEMPERATURE
display to return automatically to operational mode.
NOTE: Temperature and humidity settings may vary depending
upon product make-up and consistency. The CABINET
TEMPERATURE display shows the lowest temperature
point inside the cabinet, not the product temperature.
The capacity of the water reservoir permits uninterrupted
operation for approximately 3–6 hours, depending on the
settings and how frequently the door is opened. When "LO
H2O" is flashing on the CABINET TEMPERATURE display, add
water to the reservoir. The water reservoir refill capacity is
approximately 64 ounces, or two (2) quarts (1.9 liters).
WARNING: eLeCTRIC shOCK hAzARD — Do not overfill
water reservoir.
humidity
setting
4
5
1
4
1
4
5
4
4
12
Temperature
°F °C
130 55
175 80
140 60
140 60
175 80
185 85
180 82
140 60
180 82
Form No. FDWDM-1010