Table of Contents
Advertisement
11.4 Cleaning the air outlet and
the panel
1. Use a dry and soft cloth to wipe it.
2. Pure water or mild detergent may be
used if it is very dirty.
WARNING!
Do not use benzene, thinner,
polishing power, or similar
solvents for cleaning. These may
cause the surface tocrack or
deform.
To avoid the risk of electrical
into the indoor unit.
Never wipe the air flow louver
violently.
An air conditioner without air
of the room, which would cause
malfunctions by accumulation.
11.5
1.
2.
3.
4.
the front panel.
11.6 Preparation for extended
non-operation
If you plan to idle the unit for a long time,
perform the following:
1.
2. Operate the fan for about half a day to
dry the inside of the unit.
3. Stop the air conditioner and disconnect
power.
4. Remove the batteries from the remote
controller. The outdoor unit requires
periodic maintenance and cleaning. Do
not attempt to do this yourself. Contact
your dealer or service provider.
11.7 Pre-season inspection
1. Check that the wiring is not broken off
or disconnected.
2.
3.
4. Check if the air outlet or inlet is blocked
after the air conditioner has not been
used for a long time.
WARNING!
Do not touch the metal parts of
Injuries can occur when handling
sharp metal edges.
Do not use water to clean inside
the air conditioner. Exposure to
water can destroy the insulation,
leading to possible electric
shock.
make sure that the power and
circuit breaker are turned off.
water at more than 40ºC/104ºF.
Shake off moisture completely
and dry it in the shade. Do not
expose it directly to the sun, it
may shrink.
ENGLISH
23
Advertisement
Table of Contents
