Printer Communication Interface - Bematech LR200M User Manual

from left to right repeatedly till charging is complete and then the indicator will
stay on.
The printer can also be charged via USB port of host computer. However, the
battery cannot be recharged using power adapter and USB at the same time.
Note that charging through USB port will require longer charging time.
Normally, the battery can last for printing 100 meters or 3 hours. This parameter
is only for reference. The capacity of the battery would decrease after a long time
usage and could shorten the actual printing time.

3.3 Printer Communication Interface

(1) USB Interface
1. Connect printer to the computer with USB cable and turn on the printer.
2. Install the USB driver. The driver will create a virtual serial port.
3. Invoke "Device Manager" and check under "Ports (COM & LPT)" for the COM
port number assigned.
4. Set up POS software or utility software to the assigned COM port to
communicate with the printer.
(2) Wi-Fi Interface Setup
1. Connect printer to computer via USB port and install USB virtual serial port
driver.
2. Run the "LR200M_ConfigurationTool" utility software.
3. Select "Wifi" tab and Input the SSID name of wireless router in SSID field.
4. Choose the encryption type of wireless route based on the router you are
using. If you choose the router encryption type is "WPA-PSK/WPA2-PSK", and
authentication type is "automate", then select WPA2-PSK or WPA2-PSK and
enter the PSK key to match the router settings.
5. If the encryption type for router is "WEP", select WEP and enter the WEP key
to match the router settings.
6. Enter the desired IP address according to allocation from your network
administrator.
7. After entering all WiFi parameters, under "Port" section, select "COM Port"
option and then change the COM port number to match with the assigned
port in virtual serial driver. Configure the default baud rate of printer as
"9600" and then click "Set" to apply the WiFi settings.
10