Table of Contents
Advertisement
The bottom of Rugged PDA on the AC adaptor becomes
warm during use.
This is caused by the CPU operation or the current when Rugged PDA's bat-
・
tery is charged. This is not malfunction. The heating value charges according
to the condition of use.
When Rugged PDA or the AC adaptor is warmer than usual, shut down the
・
power, unplug the power cord of the AC adaptor and remove the battery packs.
Contact your original retailer or authorized distributor.
Do not continue operating the Rugged PDA until the bat-
tery is completely depleted.
Doing so may result in loss of or damage to your data. Recharge the battery
・
immediately if the battery is depleted.
Use the stylus provided.
When writing on the screen, be sure to use only the stylus provided (or a simi-
・
lar product with a soft tip that is not sharp). Remove any dust or dirt from the
screen and the tip of the stylus before writing on the screen. Dirt or dust makes
it difficult to write on the screen and may scratch it.
Avoid using the Rugged PDA in the following locations.
Places where there is a lot of dust
・
Be careful when using the Rugged PDA in extremely hot or cold locations,
・
such as in a car in direct sunlight, in front of heaters or heating equipment.
Places that are very humid or damp
・
Avoid vibration and strong impact.
Strong vibration or impact may damage the Rugged PDA or important data. It
・
also might damage the LCD screen.
Do not use the Rugged PDA in the rain or places where
water may get on it.
The Rugged PDA is waterproof, however water entering through the gaps around
・
buttons and switches may cause a malfunction.
If rain or water gets on the Rugged PDA, carefully wipe it with a dry cloth.
・
14
Advertisement
Table of Contents
