Nilfisk-Advance SC450 Use & Maintenance

Use & maintenance
- SC450
ATTENTION! Do not use the machine before you have read and understood the Instructions for User Manual
1a. Switch off charger by unplug
charger cable from red battery plug.
Reconnect the red battery plug to
the machine.
.
5. Place the brush or the pad-holder 6. Adjust (if needed) the brush deck
under the deck. Use the appropriate
brush to clean the floor.
10. At the end of the work. Empty
the recovery tank with the hose. Then
empty the solution tank with the
trasparent hose
15. Clean the filter by: Remove the
transparent cover and the gasket
If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to carry out this this
procedure may cause damage to the batteries. Charging the batteries after every use is recommended.
PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASIS
Nilfisk A/S Tel.: +45 43 23 40 50
Kornmarksvej 1 Fax: +45 43 43 77 00
DK-2605 Brøndby mail.com@nilfisk.com
Denmark www.nilfisk.com
1b. Disconnect the battery charger
cable from the electrical main.
to have the correct machine
directionality
11. Wash with clean water the recovery
tank and the vacuum grid
16. Clean the machine using a damp
cloth and where needed use a
neutral cleaning product
2. Fill the tank with a clean water. The
clean water temperature must not
exceed 40 °C.
7. Press the eco solution flow control
valve
12. Remove the brush/pad and clean
them
17. Charge the batteries: Connect the
battery charger cable from the
electrical main
3. If the squeegee is not connected to
the machine: install and fasten it with
the handwheels, then connect to the
suction hose
8. Switch on the brush and vac motors 9. Press the handle switch to engage
to activate the machine
13. Take the squeegee off and remove
debris.
18. Park the machine with the recovery
tank cover open
4. If the squeegee is in upper position,
lower it with the lever
the brush and run the machine
14. Check and clean the squeegee
blades