Marantz SC-7S1 User Manual page 22

7. How to operate function and how to set up
In case of 1 several units of SC-7S1
Set up ID numbers to respective SC-7S1 to extinguish each
of SC-7S1s.
q Set up ID No. switch <1> for main unit of SC-7S1 to con-
trol others, which is called <Master> unit.
The ID No. set up will be indicated for 3 seconds when
power is on.
REMOTE
ID NO. ID NO.
CONTROL
BALANCED
1
IN
MODE
OUT
STEREO
in put s el ec tor
w Set up other SC-7S1s which should be connectedly op-
BALANCED
+
CONNECTION 1 COLD 2 COLD(-) 3 HOT( )
erated by Master as ID No. <2>–<6>.
They are called <Slave> unit.
The ID No. set up will be indicated for 3 seconds when
power is on.
REMOTE
ID NO. ID NO.
CONTROL
BALANCED
1
IN
MODE
OUT
STEREO
input selector
e The Trim adjustment for Master is the same as when the
BALANCED
+
CONNECTION 1 COLD 2 COLD(-) 3 HOT( )
unit of SC-7S1 is 1pc.
r Once the set up for Trim has been finished, press Trim
mode button on Remote controller.
The trim adjustment will move from Master to Slave. Then
the indicator on Front display section of Salve will light on
Red, Sync indicator will flash Red.
TRIM MODE
A
in put s el ec tor
18
s ter e o c o n tro l a mp l i fi er s c - 7 s 1
2
3
4
5
6 SYNC B
A
AC IN
p ow e r
BI-AMP
Light Green
stereo control amplifier sc- 7s1
2
3
4
5
6
A SYNC B
AC IN
power
BI-AMP
Light RED
s ter e o c o n tro l a mp l i fi er s c - 7 s 1
EXIT
A SYNC B
TRIM
p ow e r
Light Red
Flash Red
t Please refer to p.17 for Terim adjustment as the same
method as 1 unit of SC-7S1.
If the whole system consist of more than 3 units, please
repeat the same procedure and set up remaining units.
Every pressing the Trim mode button, turn to smaller ID
number of SC-7S1 for adjustment.
y If the Trim adjustment is completed for all units, press
Exit button on Remote controller, and finish Trim mode.
RIM MODE EXIT
A TRIM
volum e
volume
volum e
ATT
B