Name And Funtion - Marantz SC-7S1 User Manual

Rear panel
INPUT
BALANCED
SACD/CD
PUSH PUSH
A
C H
B I -
A MP
PUSH PUSH
B
C H
z
z Input Balanced terminal
The terminal to connect with balanced output terminal of
SACD, CD Players.
In case of Bi-Amp mode, Input terminal of B Channel can not
be used.
Balanced terminal → p5
x Input SACD/CD, Line 1, Line 2, Tape (Un-
balanced) terminal
The terminal to connect with output terminal of SACD, CD
Players.
In case of Bi-Amp mode, Input terminal of B Channel can not
be used.
c Rec out terminal
The terminal to connect with input terminal of Recording equip-
ment such as CD recorder.
In case of Bi-Amp mode, the signal input to A channel will be
out to both of A/B channels.
v Pre out Unbalanced 1,2 terminal
The terminal to connect with Unbalanced input terniminal of
Power Amp.
In case of Bi-Amp mode, the signal input to A channel will be
out to both of A/B channels.
b Pre out Balanced terminal
The terminal to connect Balanced input terminal of Power
Amp.
In case of Bi-Amp mode, the signal input to A channel will be
out to both of A/B channels.
REC
OUT
1 LINE 2
TAPE UNBALANCED
1
x c v
PRE OUT
REMOTE
CONTROL
BALANCED
2
IN
OUT
STEREO
BALANCED
CONNECTION 1 COLD 2 COLD(-) 3 HOT(
b n m
n Remote control In/Out terminal
To connect several units of SC-7S1 by attached remote cable,
and connectedly operate them.
In terminal is for receiving control signal, Out terminal is for
sending control signal.
m ID No. switch
Whilst several SC-7S1 are connected, to set up respective ID
No. to distinguish each products.
When only 1 unit is used, the No. will be set 1. Initial setting is
<1>.
Trim adjustment in case of several units of SC-7S1 → p18
, Mode switch
The switch to change Stereo mode and Bi-Amp mode. Initial
setting is <stereo>.
G
In case SC-7S1 is used by normal 2 channel.
Setting <Stereo> mode.
G In case of complete Bi-Amp connection by 2 units of SC-
7S1.
Setting <Bi-Amp> mode.
In case of <Bi-Amp> mode, the signal input from A chan-
nel will be out to both of A/B channels through Pre-out
terminal and Rec out terminal.
Then, input terminal on B channel can not be used.
. AC IN socket
Connect to a household power outlet.

5. Name and funtion

ID NO. ID NO.
1
2
3
4
5
6
AC IN
MODE
BI-AMP
+
)
, .
13