FujiFilm Fujinon UA13x4.5BEZD-T9 Operation Manual page 58

AUXILIARY SWITCH
④
ANALOG ZOOM DEMAND
③
ZOOM MODE FUNCTION ON/OFF SWITCH
QUICKFRAME ON/OFF SWITCH
②
CAMERA COMMUNICATION ON/OFF SWITCH
①
ZOOM MODE SELECT SWITCH
⑤
The illustration shows the positions set at the factory.
①
Camera Communication ON/OFF switch
This switch changes the function of serial communication with a camera to ON and OFF.
Note.
Set this switch to "OFF" when a malfunction occurs and it is assumed that the malfunction is caused
by a serial communication failure.
② QuickFrame ON／OFF switch
This switch changes the quickframe function to ON and OFF.
③
Zoom Mode Function for Analog Zoom Demand ON/OFF Switch
In a zoom operation with an analog zoom demand control unit, the zoom mode function (function of selecting
the characteristics of "zoom speed vs zoom control signal" ) can be switched to ON and OFF.
④
Auxiliary switch An
auxiliary switch.
⑤
Zoom Mode select switch
The characteristics of "Zoom Speed
vs Rotational Angle of Zoom Seesaw
Control Lever" can be selected from
ten modes.
Refer to the following figure.
FUNCTION & MODE SELECT SWITCHES
W
Rotational Angle of zoom seesaw control lever
- 20 -
Maximum
No.9
No.4(Normal)
0
Rubber Cap
No.0
T