The Menu Commands - Elcometer UG20DL Operating Instructions Manual

22 THE MENU COMMANDS

Note: The availability of these commands depends upon the transducer type and gauge settings.
Top Level Submenu
Menu Item Item
STORE A 1
DIRECT NORTH
SOUTH
EAST
WEST
CLEAR LOC
29
Displays the current measurement reading storage location. This
location can refer to either a grid cell location (similar to a cell in a
spreadsheet), or a sequential format location, depending on which file
format was uploaded into the gauge.
Note: A grid file structure is loaded into the gauge prior to despatch
from the Elcometer NDT factory.
MEMOFF
If is selected, the
MEMOFF
by .
Part of the data logger. The submenu item selected specifies in which
direction to advance the cursor after a measurement is stored. If a two
dimensional grid format is being used, all direction options can be
used, however if a sequential file format is used, only
SOUTH
are applicable.
MEMOFF
If is selected,
Part of the data logger. If a measurement is stored by mistake, or in the
wrong location, the measurement can be cleared from memory using
DIRECT
this option. Use
CLEAR
to erase the stored measurement.
MEMOFF
If is selected,
Description
STORE
top level menu item is replaced
DIRECT
is disabled and not displayed.
to advance to the location, then select
CLEAR
is disabled and not displayed.
NORTH
and