Craftsman 917.28008 Operator's Manual page 30

REPLACING BATTERY
n_asWARNING: Do not short battery termi-
by allowing awrench or anyother object
to contact both terminals at the same time.
Before connecting battery, remove metal
bracelets, wristwatch bands, rings, etc.
Positive terminal must be connected first to
preventsparking from accidental grounding.
1. Lift hood to raised position.
2. Remove terminal cover.
3. Disconnect BLACK battery cable then
RED battery cable and carefully remove
battery from tractor.
4. Install new battery with terminals insame
position as old battery.
5. Reinstall terminal cover.
6. First connect RED battery cable to posi-
tive (+) battery terminal with bolt and nut
as shown. Tighten securely.
7. Connect BLACK grounding cable to
negative (-) battery terminal with remain-
ing bolt and nuL Tighten securely
8. Close hood.
TO REMOVE HOOD AND GRILL AS-
SEMBLY
1. Raise hood.
2. Unsnap headlight wire connector.
3, Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
4. When replacing hood, be sureto recon-
nect the headlight wire connector.
Hood
Headlight Wire
Connector-
TRANSMISSION
REMOVAL/REPLACEMENT
Should yourtransmission require removalfor
service or replacement, it should be purged
after reinstallation and before operating the
tractor. See "PURGE TRANSMISSION" in
the Operation section of this manual,
TO REPLACE HEADLIGHT BULB
1. Raise hood.
2. Remove bulb hotder from the hole in the
backside of the grill.
ENGINE
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at
the factory and adjustment should not be
necessary Check adjustment as described
below before loosening cable. If adjustment
is necessary, see engine manual.
TO ADJUST CHOKE CONTROl.
3: Replace bulb inholder and install bulb ....... The choke controi been preset at
holder securely back into the hole inthe the factory and adjustment should not be
backside of the grill.
4. Close hood,
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly,stop running, or prevent
it from starting,
° Check wiring.
TO REPLACE FUSE
Replace with30 amp automotive-type plug-
in fuse. The fuse holder is located behind
the dash.
necessary. If adjustment is necessary, see
engine manual,
TO ADJUST CARBURETOR
Your carburetor has been preset at the factory
and adjustment should not be necessary.
However, minor adjustment may be required
to compensate for differences in fuel, tem-
perature, altitude or load. If the engine does
need adjustment, see engine manual.
3O