WARNING: TO AVOIDSERIOUSINJURY,BEFOREPERFORMING ANY SERVICEOR
ADJUSTMENTS:
• Depress clutch/brake pedal fully and set parking brake.
• Place attachment clutch in "DISENGAGED" position.
4. Turn ignition key to "STOP" and remove key,
5. Make sure the blades and all moving parts have completely stopped.
6. Disconnect spark plug wire from spark plug and place wire where it cannot come
in contact with plug•
TO REMOVE
MOWER
I. Place attachment
clutch in "DISEN-
GAGED" position.
2. Lower attachment lift lever to its lowest
position.
3, Disengage belttension rod (K)from lock
bracket (L).
_, CAUTION: Belt tension rod is spring
loaded. Have a tight grip on rod and release
slowly.
4. Remove mower belt from electric clutch
pulley (M).
5. Disconnect front link (E) from mower -
remove retainer spring and washer.
6. Go to either side of mower and discon-
nect mower suspension arm (A) from
chassis and rear lift link (C) from rear
mower bracket (D) - remove retainer
springs and washers.
7. Go to other side of mower anddisconnect
_the
suspension arm and rear lift link•
CAUTION: After rear lift links are discon-
nected, the attachment lift teverwillbe spring
loaded. Have a tight grip on liftlever when
changing position of the lever.
8. From right side of mower, disconnect
anti-sway bar (S) from right rear mower
bracket (D) - remove retainer spring and
washer and pull mower toward you until
the bar fails from the hole in bracket,
9. Turn tractor steering wheel to the left as
far as it will go,
10. Slide mower out from under right side of
tractor,
TO INSTALL MOWER
Follow procedure described in "INSTALL
MOWERAND DRIVE BELT" intheAssembly
section of this manual.
26