Led Indicator - ZLG CANWiFi-200T User Manual

Guangzhou ZHIYUAN Electronics Co., Ltd.
CAN port
CAN0
Note: the corresponding terminal resistance is configured through using a wire to connect CANx-H and
CANx-R.

2.6 LED Indicator

CANWiFi-200T has three indicators, including POWER, SYS and WiFi/LAN, as shown
in Figure 2-6.
The description of the three LED indicators on the left is listed in Table 2-3.
LED
POWER
SYS
WiFi/LAN
The two CAN ports of the CANWiFi-200T have one LED indicator respectively. The
description is shown in Table 2-4.
User Manual
Date: 2017/08/04
High performance 2-channel WiFi-to-CAN Converter
C
Signal
CAN0-L It is the CANL signal terminal of CAN0.
It is the terminal through which CAN0 channel is
CAN0-G
connected with the shielding layer.
It is the CANH terminal of CAN0 and the connection
CAN0-H
terminal of signal terminal resistance.
Another connection terminal of the CAN0 terminal
CAN0-R
resistance (connected with CAN0-L internally)
Figure 2-6: CANWiFi-200T LED indicators
Table 2-3: Description of LED indicators
Power indicator. It always lights after power-on.
System operation indicator. If the device is not ready or
has fault, the yellow light is always on. If the device
operates normally, the yellow light flashes.
WiFi and LAN operation indicator. The green light is on
when WiFi is connected, and the yellow light is on when
the network cable is connected.
CANWiFi-200T User Manual
Introduction
Description
©2017 Guangzhou ZHIYUAN Electronics
9
V1.02