Installing The Storage Module - Cisco UCS B200 M4 Installation And Service Note
Blade server
Hide thumbs
Also See for UCS B200 M4:
- Installation and service note (30 pages) ,
- Upgrade manual (9 pages) ,
- Servicing manual (24 pages)
Table of Contents
Advertisement
Installing the Storage Module
Installing the Storage Module
Procedure
Step 1
Place the storage module over the two standoff posts on the motherboard at the front of the server.
Step 2
Press down on the drive bay cage where it is labeled "Press Here to Install" until the storage module clicks
into place.
Figure 10: Storage Module
Step 3
Using a Phillips-head screwdriver, tighten the four screws to secure the storage module. The locations of the
screws are labeled "Secure Here."
Cisco UCS B200 M4 Blade Server Installation and Service Note
18
Servicing a Blade Server
Hide quick links:
Advertisement
Table of Contents
