Removal & Installation - Simplicity 1691682 Service & Repair Manual

7 Transmission Repair
7E Tuff Torq K210A
Removal & Installation
1. Elevate the rear end. See Elevating Rear End for
Safe Service.
2. Remove the wheels. See Rear Wheel Removal
NOTE: If the transaxle is to be rebuilt, it is recommend-
ed that the oil be drained at this time. The drain plug is
located at the bottom left of case. When refilling, use
124 oz. of 10W-30 engine oil.
3. Unhook front of shift interlock return spring from inter-
lock lever on front left side of transaxle.
4. Remove cotter pin and washer holding shift interlock
rod to interlock lever.
5. Depress clutch pedal and remove transaxle drive belt
from input shaft pulley on top of transaxle.
6. Remove nut and washer holding ball joint to transaxle
shift lever.
7. Remove cotter pin and washer holding brake rod to
brake lever on right side of transaxle.
Figure E-3 Oil Drain Plug Location
Interlock Rod
Figure E-4. Remove Shift Interlock Linkage
Ball Joint to
Shift Lever
Figure E-5. Remove Shift Rod Ball Joint
7 - 60
Drain Plug
Return Spring
Interlock Lever