Simplicity 1691682 Service & Repair Manual page 132

6 General Repair
6D Hood, Dash, & Grill Repair
2. Disconnect the headlight wire harness at the two pin
connector (D, Figure D–3) located near the oil fill tube
on the right side of the engine. Thread the wire har-
ness out through the engine lift bracket and remove it
from the speed clip attaching the harness to the
hood.
3. Using needle-nose pliers, remove the clip (A, Figure
D–4) on each of the hood pivot points.
4. Slide out and remove the hood pivot spacer (B) from
each of the hood hinges.
5. Lift the hood off of the tractor.
6. For hood installation, perform Steps 1 through 5 in
reverse order.
B
A
Figure D–3. Headlight Assembly
A. Lens
B. Bezel
B
Hood Hinge
Figure D–4. Hood Hinge Assembly
A. Clip
B. Pivot Spacer
6 - 62
C
D
C. Bulb Socket
D. Pin Connector
A