Step 1: Ratchet And Rail Holder Installation; Step 2: Height Adjustable Leg Assembly - Baby Lock Momentum BLQM Assembly And Use Instruction Manual

Step 1: Ratchet and Rail Holder Installation

Parts Needed
1- Right Frame End
1- Left Frame End
1- Top Rail Ratchet Assembly
1- Rail Holder Assembly
Tools Required
4mm Allen Wrench
1-1: Insert the Top Rail Ratchet Assembly into the Right Frame End tube end
and tighten the M6 x 25mm SBHCS. (Fig. 1-2)
1-2: Insert and fasten the Rail Holder Assembly into Left Frame End tube
end. (Fig. 1-3)

Step 2: Height Adjustable Leg Assembly

Parts Needed
1- Right Frame End
1- Left Frame End
1- Middle Leg
Tools Required
5mm Allen Wrench
Open Wrench 13mm and 10mm
Height of Fabric Surface Chart
(Height is determined by the quilting surface to the floor.)
Top Hole 44"
8th 43"
7th 42"
6th 41"
5th 40"
2-1: To adjust the legs, remove the pre-installed M8 x 55mm
SBHCS, M8 Flat Washer, and M8 Nylock Nut from the frame
ends and middle leg if assembling in King size. (Fig. 2-1)
2-2: Adjust the leg height using the Height of Fabric Surface
Chart. The bottom of the machine handles typically start at
about 8" above the Quilting surface. Determine what setting
will be most comfortable for you based on your height.
2-3: Fasten the M8 x 55mm SBHCS, M8 Flat Washer, and M8
Hex Nut to the adjusted legs with the tools provided. (Fig.
2-1)
Frame Assembly
4th 39"
3rd 38"
2nd 37"
Bottom Hole 36"
Top Rail Ratchet
Assembly (Right)
Fig. 1-1
Fig. 1-2
Rail Holder Assembly
(Left)
Fig. 1-3
Fig. 2-1
Right Frame End
Left Frame End
M8 Hex Nut
M8 Flat Washer
M8 x 55mm SBHCS
Page. 5