Table of Contents
Advertisement
6-2: Fasten a set of M8 x 50mm SBHCS and M8 Nylock
Nuts through the second hole from the bottom of the Rail
Brackets as a default. (Fig. 6-2 and Fig. 6-3)
Step 7: Take Up Rail Bracket Assembly
Parts Needed:
1- Take Up Rail Right Arm Ratchet End
1- Take Up Rail Left Arm Rail Holder End
2- M8 x 50mm SBHCS
2- M8 Nylock Nut
Tools Required:
5mm Allen Wrench
Open Wrench 13mm and 10mm
Note: The height may need to be adjusted after
the sewing machine has been set on the frame.
This assembly step is universal for both Crib and
King size frames.
7-1: Insert the Rail Brackets into the corresponding
tube ends. (Fig. 7-1)
7-2: Fasten a set of M8 x 50mm SBHCS and M8
Nylock Nuts through the middle hole of the Rail Arm
Brackets. (Fig. 7-1)
Step 8: Bottom Carriage Assembly
Parts Needed:
2- M6 Set Screw
1- Sensor Bracket
1- Carriage Assembly (included
with sewing machine)
1- Master Board Box
1- Power Supply
Tools Required:
3mm Allen Wrench
8-1: Attach and align the Sensor Bracket to the
backside of the carriage. The Sensor Bracket tab
should be flush against the rear of the carriage.
(Fig. 8-1)
8-2: Insert and fasten a set of M6 Set Screws
into the Sensor Bracket. (Fig. 8-2)
M8 Nylock Nut
M8 x 50mm SBHCS
Fig. 6-3
Non-Ratchet End
Fig. 7-1
Fig. 8-1
Fig. 8-2
Take Up Rail Left Arm Rail Holder End
Take Up Rail Right Arm Ratchet End
Ratchet End
Backside of
the carriage
Sensor
Bracket tab
M6 Set Screw
Page. 10
Hide quick links:
Advertisement
Table of Contents
