Table of Contents
Advertisement
8-3: Position the Master Board Box so that the
two ports are facing the front of the carriage.
Peel the tape from the back of the Master Board
Box and attach the box to the side of the Car-
riage Assembly. (Fig. 8-3)
8-4: Plug the Front Cable into the Front Port
and Rear Cable into the Rear Port on the Master
Board Box. (Fig. 8-4)
Step 9: Track Adjustment
Parts Needed:
1- Bottom Carriage Assembly
1- Frame Assembly
Tools Required:
4mm Allen Wrench
Note: This assembly step is universal for both
Crib and King size frames.
9-1: Place and align the Bottom Carriage As-
sembly on the track assemblies. The Front Track
Assembly should be loosely fastened from a
previous step. (Fig. 9-1)
9-2: The Rear Track Support should be aligned
flush with the Table Frame Side from a previous
step. If not, align and securely fasten. (Fig. 9-1)
9-3: Press down on the Bottom Carriage As-
sembly and move the carriage from left to right,
fastening the Front Track M6 Connector Bolts
firmly. Continue this step for the remainder of
the Connector Bolts along the frame. (Fig. 9-2)
Fig. 8-3
Fig. 8-4
Fig. 9-1
Fig. 9-2
Front Cable
Rear Cable
Rear Track Side
Rear Frame Side
M6 Connector Bolts
Master Board Box
Front
Rear
Page. 11
Hide quick links:
Advertisement
Table of Contents
