Step 12: Idler Rail Clamp Attachment To Frame - Baby Lock Momentum BLQM Assembly And Use Instruction Manual

Step 12: Idler Rail Clamp Attachment to Frame

Parts Needed:
1- Idler Rail Assembly
1- Rail Clamp Lock Pin Assembly
1- M6 x 16mm SBHCS
Tools Required:
4mm Allen Wrench
Note: This assembly step is universal for
both Crib and King size frames.
12-1: Insert the Idler Rail Assembly
through the throat of the machine and
clamp locking end into the Front Rail
Bracket Ratchet End rear hole. (Fig. 12-1)
12-2: Rotate the Idler Rail Assembly so
that the Clamp Lock Rail End square Key is
facing forward. (Fig. 12-2)
12-3: Clip the Non-Ratcheting Floating
End into Front Rail Bracket Non-Ratchet
rear coupler. (Fig. 12-3)
12-4: Align the keyed ends of the Idler Rail Assembly clamp locking end with the Rail Clamp Lock Pin end.
Attach the Rail Clamp Lock Pin Assembly to the Idler Rail Clamp Locking Assembly by fastening the M6 x
16mm SBHCS with a 4mm Allen Wrench. (Fig. 12-4)
Fig. 12-3
Clamp Lock Rail End Key
Front Rail Bracket Non-Ratchet rear coupler
Idler Rail Assembly clamp locking end key
Idler Rail Assembly clamp locking end
Front Rail Bracket Ratchet End rear hole
Fig. 12-1
Fig. 12-2
Rail Clamp Lock Pin end key
Foward
Rail Clamp Lock Pin Assembly
M6 x 16mm SBHCS
Fig. 12-4
Page. 14