Operation - Makita DSD180 Instruction Manual

1
1. Blade cap 2. Hook
Hex wrench storage
When not in use, store the hex wrench as shown in the
1. Hex wrench
Connecting a vacuum cleaner
Connect a Makita vacuum cleaner for clean operation.
Remove the rubber cap on the dust collector and con-
nect the vacuum cleaner's hose to the nozzle of the
dust collector.
1. Dust collector 2. Rubber cap 3. Vacuum cleaner
hose
2
1
1 2
3

OPERATION

CAUTION:
CAUTION:
the workpiece during cutting. Never perform a
curved cut. Failure to do so may cause blade break-
the blade position when cutting.
The base cover of the tool
1
2
3
1. V-notch 2. Convexed portion 3. Blade
NOTE: For accurate cutting, it is recommended to
draw cutting lines on the workpiece beforehand.
1.
tool so that the front edge of the base touches the work-
with the cutting line.
2. Slowly pull the trigger without the blade making
any contact with the workpiece. When the blade attains
blade pierces the workpiece, make the whole surface of
the base cover contact with the workpiece.
9 ENGLISH