Operation - Makita DHS475 Instruction Manual

4
► 1 . Hex bolt 2. Outer flange 3. Circular saw blade
4. Inner flange
To install the circular saw blade, follow the removal
procedure in reverse.
The inner flange has a certain diameter protrusion on
one side. Mount the inner flange onto the mounting
shaft so that the correct side of protrusion on the inner
flange faces outward and then place the circular saw
blade and outer flange.
1 2
► 1 . Mounting shaft 2. Inner flange 3. Circular saw
blade 4. Outer flange 5. Hex bolt
WARNING:
BE SURE TO TIGHTEN THE HEX
BOLT CLOCKWISE SECURELY. Also be careful
not to tighten the bolt forcibly. Slipping your hand
from the hex wrench can cause a personal injury.
WARNING:
Make sure that the protrusion "a"
on the inner flange that is positioned outside fits
into the saw blade hole "a" perfectly. Mounting the
blade on the wrong side can result in the dangerous
vibration.
1
2
3
5
4
3
12 ENGLISH
Blade guard cleaning
When changing the circular saw blade, make sure to
also clean the upper and lower blade guards of accu-
mulated sawdust as discussed in the Maintenance
section. Such efforts do not replace the need to check
lower guard operation before each use.
Connecting a vacuum cleaner
When you wish to perform clean cutting operation,
connect a Makita vacuum cleaner to your tool. Connect
a hose of the vacuum cleaner to the dust nozzle as
shown in the figure.
1
2
► 1 . Dust nozzle 2. Screw
1
► 1 . Hose 2. Vacuum cleaner

OPERATION

This tool is intended to cut wood products only.
Refer to our website or contact your local Makita dealer
for the correct circular saw blades to be used for the
material to be cut.
2