Heat & Glo ESCAPE-30LP-IFT Installation Manual page 33

PLACE LOG
ON FLAT SPOT
5
GROOVE MATES
WITH GRATE BAR
Figure 8. Place Log #5
Log #5 (SRV2202-705): See Figures 2 and 3 for additional references. Place the thick end of Log #5 on the flat spot of
Log #1. Locate the groove on the thin end of the log. Mate the groove with the grate bar as shown above. Center the tip
of Log #5 between the ends of Log #3 and Log #4.
PLACE LOG
ON FLAT SPOT
PLACE LOG
ON FLAT SPOT
Figure 9. Place Log #6
Log #6 (SRV2202-706): See Figures 2 and 8 for additional references. Place the thick end of the log on the flat spot of Log
#2. Place the thin end of Log #6 on the flat spot of Log #5 as shown in Figure 9.
Heat & Glo • ESCAPE-35-IFT, ESCAPE-30-IFT Installation Manual • 2550-980 Rev. B • 6/18
FLAT SPOTS
FOR LOG #6
CENTER
BETWEEN
LOG #3 AND
LOG #4
6
2202-935E
33